How To Drain a Water Heater Tank

One of the best ways to extend the life of your water heater and ensure it operates efficiently is to flush the tank annually to remove sediment buildup. The process is straightforward, here are the steps:

Shut off the water supply. Locate the cold water supply valve at the top of the water heater and turn it to the off position.
Turn off the water heater. If you have a gas water heater, simply turn the thermostat knob to the “pilot” setting. If the water heater is electric, turn off the power at the breaker panel.
Attach a garden hose to the drain valve located near the bottom of the tank. Place the other end of the hose near a floor drain, in a bucket (have several large buckets to empty into and rotate them if needed) or outside the home. CAUTION: Even though a water heater may be off for hours, the water in the tank may still be hot enough to scald.
Open a hot water tap. Open a hot water tap on a floor above that is nearest the water heater. This will relieve pressure in the system, helping the water drain from the tank.
Open the drain valve. After all the water has drained from the tank, turn the cold water supply at the top of the tank back on for a moment. This will clear out any remaining sediment. Repeat this step until the water runs clear.

When you're finished draining the tank, return it to operating condition by following these steps:

Close the drain valve
Remove the hose
Turn on the cold water supply and refill the tank.
Return to the hot water tap you opened earlier. Once cold water begins to flow from the tap, turn it off.
Turn the gas valve back on from the pilot position or turn electricity back on to the tank.
Check the valve opening to ensure it's not leaking.

IMPORTANT: Always read and follow all manufacturer’s directions and warnings for your particular water heater. Some water heater tanks need to be completely filled to avoid damage to the gas burner or heating elements. Need help maintaining your water heater? Call ABC Plumbing, Sewer, Heating, Cooling and Electric. We can help with all your home plumbing needs.

Related Services

Our Blog

VIEW ALL BLOGS

A man standing at his sink, which is surrounded by plants, filling up a black tea kettle.

How to Fix a Blank White Rodgers Thermostat

You might have experienced the worry that comes with discovering your White Rodgers thermostat has gone blank. The good news is that usually, the unit can be brought back to life. In this blog, let's look at some ways to get your blank White Rodgers thermostat operating again.

What Causes Pink Stains on Toilets and Bathtubs?

The blog explains that pink stains commonly found in bathrooms are caused by a bacteria called Serratia marcescens, which thrives in moist environments. When diluted by water, this bacteria produces a red-orange pigment that results in pinkish stains on surfaces like bathtubs, toilets, and showers.
READ MORE
AC Maintenance Guide

The blog talks about the importance of maintaining your AC unit and provides advice on how to maintain older units. It also suggests replacing units when the cost of repairs becomes too high. Finally, it provides information on how to schedule AC maintenance with ABC Plumbing, Sewer, Heating, Cooling & Electric in Chicago and the surrounding areas.
READ MORE
What Is That Gurgling Under My Sink?

The blog discusses two common causes of gurgling sounds from under sinks: clogs forming in the pipes and blocked vent pipes. Clogs occur due to various materials going down the drain, while blocked vent pipes create a vacuum, hindering water flow. It advises contacting a plumber for expert assistance in clearing clogs or removing blockages to resolve the issue.
READ MORE